The tattoo has been more and more popular during these years, especially in the religions and western countries. As for the tattoo, the tattoo machine is by no means the most important tool. To master the machine well you can easily tattoo the design that you want perfectly. In fact, there is a screw in the tattoo machine, which is the key of the tattoo machine, so you must pay more attention to. The screw are located at the top of the tattoo machine and you can adjust the speed and amperage of the machine by this part. Then some suggestions are given to about how to adjust the tattoo machine properly.
The needles are closely link to the screw in the tattoo machine. You can turn the screw with your finger to adjust the speed of the needles. If loosening the screw, the needles will slow down. On the contrary, tightening will speed up the needles. So you should tightening the screw when you are performing on the loose skin. Then a Allen wrench are used to turn the screw to drop the guard that block the spring. These two steps are very easy, isn’t it? Then comes a more complex one. As we all know, there is a basic rule about the spring, the tighter the spring, the harder the throw will be. While the throw will decide how hard the needles punch. Next, the punch will influence the depth of the needles into the skin. In all, if you would like to tattoo more deeply, you should tighten the spring, then the throw will be harder, the punch will be bigger, finally the needles will be deeper. To master the depth properly is quite important in the tattoo process. If the needle goes too deep, the tattoo process will be more painful. While if not, the tattoo will be fading quickly.
The methods to adjust the tattoo machine are mainly rely on the control of the screw and the spring. These are not very difficult things, you will make it only if you can be more careful.
How To Tattoo - Tattoo Design 